Specifications

13-5
Cisco Aironet Access Point Software Configuration Guide
OL-0657-07
Chapter 13 Diagnostics and Troubleshooting
Using Diagnostic Pages
access point’s available frequencies are listed vertically across the bottom of the
graph, from 2412 to 2462 GHz. The access point’s channel 1 is 2412 GHz,
channel 2 is 2417 GHz, and so on up to channel 11, which is 2462 GHz.
The bar graph on the right side of the window displays the amount of noise on
each frequency. Noise is a measurement of the signal the radio receives when it is
not receiving packets. Even in an environment in which the radio receives a great
deal of noise, it might also receive a strong data signal. Click Stop Test in the
window or on the Radio Diagnostics page to stop the test.
VLAN Summary Status
Click VLAN Summary Status to reach the VLAN Summary Status page for your
access point. Figure 13-4 shows a typical VLAN Summary Status page.
Figure 13-4 VLAN Summary Status Page
Clicking the VLAN Detailed Setup link at the top of the page takes you to the
VLAN Setup page, from which you can add, remove, or edit your VLAN
configuration.
Service Sets
The Service Sets link takes you to the AP Radio Service Set Summary Status page
for your access point. shows a typical SSID Summary Status page for the radio.
Figure 13-5 AP Radio Module Service Set Summary Status Page