Specifications

Chapter 8 Security Setup
Setting Up EAP Authentication
8-28
Cisco Aironet Access Point Software Configuration Guide
OL-0657-07
Figure 8-9 AP Radio Identification Page
Step 3
Enter the network username you set up for the access point in Step 1 in the LEAP
User Name entry field.
Step 4 Enter the network password you set up for the access point in Step 1 in the LEAP
Password entry field.
Step 5 Click OK.
Step 6 Follow the steps in the “Enabling EAP on the Access Point” section on page 8-20
to enable Network-EAP on the repeater access point.
The next time the repeater reboots, it performs LEAP authentication and
associates to the root access point.
Note If the repeater access point fails to authenticate because the root
access point or the RADIUS server is not set up correctly, you must
reboot the repeater access point after correcting the problem. The
repeater access point does not attempt to reauthenticate until it
reboots.