Specifications

7-13
Cisco Aironet Access Point Software Configuration Guide
OL-0657-07
Chapter 7 Configuring Other Settings
Association Table Display Setup
Installed Network Routes List
The list of installed routes provides the destination network IP address, the gateway, and the subnet mask
for each installed route.
Association Table Display Setup
You use the Association Table Filters and the Association Table Advanced pages to customize the
display of information in the access point’s Association Table.
Association Table Filters Page
Figure 7-7 shows the Association Table Filters page.
Figure 7-7 Association Table Filters Page
Follow this link path to reach the Association Table Filters page:
1. On the Summary Status page, click Setup.
2. On the Setup page, click Display Defaults under Associations.
You can also reach the Association Table Filters page through the “additional display filters” link on the
Association Table page. When you reach the page through the “additional display filters” link, four
buttons appear at the bottom of the page that are different from the standard buttons on management
system pages. The buttons include:
• Apply—Applies your selections to the Association Table and returns you to the Association Table
page.
• Save as Default—Saves your selections as new default settings and returns you to the Association
Table page.