Specifications

7-10
Cisco Aironet Access Point Software Configuration Guide
OL-0657-07
Chapter 7 Configuring Other Settings
Entering FTP Settings
Domain Name System
If your network uses a Domain Name System (DNS), select Enabled to direct the access point to use the
system. If your network does not use DNS, select Disabled.
Default Domain
Enter the name of your network's IP domain in the entry field. Your entry might look like this:
mycompany.com
The Current Domain line under the entry field lists the domain that is serving the access point. The
current domain might be different from the domain in the entry field if, on the Boot Server Setup page,
you have DHCP or BOOTP set as the Configuration Server Protocol, but you selected No for the setting
“Use previous Configuration Server settings when no server responds?”
Domain Name Servers
Enter the IP addresses of up to three domain name servers on your network. The Current lines to the right
of the entry fields list the servers the access point is currently using, which may be specified by the
DHCP or BOOTP server.
Domain Suffix
In this entry field, enter the portion of the full domain name that you would like omitted from access
point displays. For example, in the domain “mycompany.com” the full name of a computer might be
“mycomputer.mycompany.com.” With domain suffix set to “mycompany.com,” the computer's name
would be displayed on management system pages as simply “mycomputer.”
Entering FTP Settings
You use the FTP Setup page to assign File Transfer Protocol settings for the access point. All
non-browser file transfers are governed by the settings on this page. Figure 7-5 shows the FTP Setup
page:
Figure 7-5 The FTP Setup Page