Specifications

5-15
Cisco Aironet Access Point Software Configuration Guide
OL-0657-07
Chapter 5 Configuring Filters and Quality of Service
Applying QoS
By Filter
Access point and bridge filters already allow the classification of traffic based upon Ethertype, Internet
Protocol, or IP Port. An example of a filter classifying traffic is shown on Figure 5-13.
Figure 5-13 Filters Priority Setting
The filters can be applied on interfaces or as a part of a VLAN policy group.
The access point has a default filter to classify all Spectralink voice traffic with voice priority. You do
not have to enable this filter, but you can modify the filter and apply it to a specific VLAN or interface.
Note To set up a filter, see the “Filter Setup” section on page 5-2.
A typical Spectralink filter configuration is shown on Figure 5-14.
Figure 5-14 Spectralink Filter Configuration