Specifications

5-3
Cisco Aironet Access Point Software Configuration Guide
OL-0657-07
Chapter 5 Configuring Filters and Quality of Service
Filter Setup
Figure 5-2 Protocol Filters Page
Follow this link path to reach the AP Radio or Ethernet Protocol Filters page:
1. On the Summary Status page, click Setup.
2. On the Setup page, click Filters in the AP Radio or Ethernet row under Network Ports.
The left side of the Protocol Filters page contains links to the Ethertype Filters, the IP Protocol Filters,
and the IP Port Filters pages.
Use the Protocol Filters pages to assign protocols to a filter set. Table B-1, Ta ble B-2, and Table B-3 in
Appendix B list the protocols available on each page.
Creating a Protocol Filter
Follow these steps to create a protocol filter:
Step 1 Follow the link path to the Protocol Filters Setup page.
Step 2 Click Ethertype, IP Protocol, or IP Port to display the Filters page that contains the protocols you want
to filter. Figure 5-3 shows the IP Protocol Filters page.
Figure 5-3 IP Protocol Filters Page
Step 3
Enter a descriptive filter set name in the Set Name field.
Step 4 Enter an identification number in the Set ID entry field if you want to assign a specific SNMP identifier
to the filter set. If you don’t enter an ID, an SNMP identifier will be assigned to the set automatically,
starting with 1 for the first filter set and incrementing by one for each additional set.
Step 5 Click Add New. The Filter Set page appears. Figure 5-4 shows the Filter Set page.