Specifications

4-16
Cisco Aironet Access Point Software Configuration Guide
OL-0657-07
Chapter 4 Configuring VLANs
A Wireless VLAN Deployment Example
Step 3 In the Existing SSIDs field, highlight the tsunami (primary) SSID and click Edit. The AP Radio Primary
SSID page appears (Figure 4-9).
Figure 4-9 AP Radio Primary SSID Page
Step 4
Make the following changes to this page:
a. Rename the Primary SSID to Native VLAN.
b. Maximum under of Associations: 0
c. Default VLAN ID: [1] Native VLAN.
Note Associating the Default VLAN ID to the native VLAN field is known as mapping the VLAN to
the SSID. The mapping process is how the access point is able to “connect” to the VLAN on the
switch.
d. Classify Workgroup Bridges as Network Infrastructure: yes
e. Accept Authentication Type: Shared and Network EAP
f. Default Unicast Address Filter: Allowed for each authentication type.
Step 5 Click OK. The AP Radio Service Sets page appears.
Step 6 In the Service Set ID (SSID) field, enter full-time and click Add New. The AP Radio SSID #1 page
appears (Figure 4-11).
Step 7 Map the full-time SSID to the full-time VLAN ID by following these steps:
a. Highlight the full-time SSID.
b. In the VLAN ID drop-down menu, select [2] full-time VLAN ID.
Step 8 Select Network-EAP authentication type and allow default unicast address filters.
Step 9 Click OK to save your settings and return to the AP Radio Service Sets page.