Specifications

4-13
Cisco Aironet Access Point Software Configuration Guide
OL-0657-07
Chapter 4 Configuring VLANs
A Wireless VLAN Deployment Example
Creating the Full- and Part-Time VLANs
The full- and part-time VLANs are essentially the same except for their names and SSIDs. Follow these
steps to create these VLANs.
Step 1 On the VLAN Setup page, make the following changes:
a. VLAN (802.1Q) Tagging: Disabled
b. Native VLAN ID: 0
c. Single VLAN which allows Unencrypted packets: 0
d. Optionally allow Encrypted packets on the unencrypted VLAN: yes
e. VLAN ID: 2
f. VLAN Name: Full-Time
Step 2 Click Add New. The VLAN ID #2 page appears.
Step 3 Make the following entries on this page:
a. VLAN Name: Full-Time
b. VLAN Enable: Enabled
c. Default Priority: default
d. Default policy group: [0] None
e. Enhanced MIC verification for WEP: None
f. Temporal Key Integrity Protocol: Cisco
g. WEP Key Rotation Interval: 0
h. Alert?: no
i. WEP Key 1: Enter 26 hexadecimal characters.
j. Key Size: 128 bit
Step 4 Click OK to save your settings and return to the VLAN Setup page.
Step 5 Create the Part-Time VLAN using the same settings as Full-Time with the following exceptions:
a. VLAN ID: 3
b. VLAN Name: Part-Time
Step 6 Click Add New. The VLAN ID #3 page appears.
Step 7 Make the same entries for this page as you did for the Full-Time VLAN.
Step 8 Click OK to save your settings and return to the VLAN Setup page.