Specifications

H-3
Cisco Aironet 1200 Series Access Point Installation and Configuration Guide
OL-3446-01
Appendix H Error and Event Messages
PMIP-6-STOP: Proxy Mobile IP
services have stopped
Proxy Mobile IP service has stopped. None.
PMIP-6-REPEATER_STOP: AP is now
operating as a repeater, disabling Proxy
Mobile IP services
Proxy Mobile IP does not run on
repeaters or workgroup bridges, and it is
disabled automatically when the access
point is in repeater mode.
None.
Unzip Messages
SOAP-4-UNZIP_OVERFLOW: Failed
to unzip
Flash:/c1200-k9w7-mx.122-3.6.JA1/ht
ml/level15/ap_xxx.htm.gz, exceeds
maximum uncompressed html size
The HTTP server cannot retrieve a
compressed file in response to an HTTP
GET request because the size of the file is
too large for the buffers used in the
uncompression process.
Make sure file is a valid HTML page. If
so, you'll have to copy an
uncompressed version of the file into
Flash to retrieve it through HTTP.
802.11 Subsystem Messages
DOT11-6-FREQ_INUSE: Radio
frequency [int] is in use
When scanning for an unused frequency,
the unit recognized another radio using
the displayed frequency.
None.
DOT11-6-FREQ_USED: Radio
frequency [int] selected
After scanning for an unused frequency,
the unit selected the displayed frequency.
None.
DOT11-4-VERSION_MISMATCH:
Require radio version [hex].[int], found
version [hex].[int]
When starting the radio, the wrong
firmware version was found. The radio
will be loaded with the required version.
None.
DOT11-2-VERSION_INVALID:
Unable to find required radio version
[hex].[int]
When trying to re-flash the radio
firmware, the access point recognized
that the radio firmware packaged with the
IOS firmware had the incorrect version.
None.
DOT11-4-NO_SSID: No SSIDs
configured, radio not started
All SSIDs were deleted from the
configuration. At least one must be
configured for the radio to run.
Configure at least one SSID on the
access point.
DOT11-4-FLASHING_RADIO:
Flashing the radio firmware ([chars])
The radio has been stopped to load new
firmware.
None.
DOT11-2-NO_FIRMWARE: No radio
firmware file ([chars]) was found
When trying to Flash new firmware into
the radio, the file for the radio was not
found in the Flash file system.
The wrong image has been loaded into
the unit. Locate the correct image based
on the type of radio used.
DOT11-2-BAD_FIRMWARE: Radio
firmware file ([chars]) is invalid
When trying to Flash new firmware into
the radio, the file was found to be invalid.
Put the correct firmware image file in
the place where the unit is looking.
DOT11-4-FLASH_RADIO_DONE:
Flashing the radio firmware completed
The radio firmware Flash is complete,
and the radio will be restarted with the
new firmware.
None.
DOT11-4-LINK_DOWN: Radio parent
lost: [chars]
The connection to the parent access point
was lost for the displayed reason. The
unit will try to find a new parent access
point.
None.
Table H-1 Error and Event Messages (continued)
Message Explanation Recommended Action