Specifications

G-2
Cisco Aironet 1200 Series Access Point Installation and Configuration Guide
OL-3446-01
Appendix G Access Point Specifications
Power Output 100, 50, 30, 20, 5, or 1 mW
(Depending on the regulatory domain in
which the access point is installed)
40 mW (16 dBm)
20 mW (13 dBm)
10 mW (10 dBm)
5 mW (7 dBm)
Note These values are based on the FCC peak
measurement method as defined in
FCC 15.407 (A)(4)
Frequency 2.400 to 2.497 GHz
(Depending on the regulatory domain in
which the access point is installed)
UNII 15.15 to 5.25 GHz
UNII 25.25 to 5.35 GHz
(Depending on the regulatory domain in which the
access point is installed)
Range Indoor:
150 ft at 11 Mbps
350 ft at 1 Mbps
Outdoor:
800 ft at 11 Mbps
2000 ft at 1 Mbps
Indoor:
170 ft at 6 Mbps
130 ft at 18 Mbps
60 ft at 54 Mbps
Outdoor:
1000 ft at 6 Mbps
100 ft at 54 Mbps
Modulation Direct Sequence Spread Spectrum (DSSS) Orthogonal Frequency Division Multiplex (OFDM)
Data rates 1, 2, 5.5, and 11 Mbps 6, 9, 12, 18, 24, 36, 48, and 54 Mbps
Antenna A diversity system with two reverse-TNC
connectors (Cisco antennas are sold
separately).
A diversity system consisting of two integrated
omnidirectional and two integrated directional
antennas.
Compliance The 1200 series access point complies with UL 2043 for products installed in a buildings
environmental air handling spaces, such as above suspended ceilings.
Caution The 1200 series power injectors are not tested to UL 2043 and should not be placed in a
buildings environmental air space, such as above suspended ceilings.
Note If you plan to mount the access point in environmental air space using a 5-GHz radio, Cisco
recommends that you mount the access point horizontally with its antennas pointing down.
Doing so results in the access point complying with regulatory requirements for
environmental air space with the 5-GHz radio installed.
Safety Designed to meet:
UL 1950 Third Edition
CSA 22.2 No. 950-95
IEC 60950 Second Edition, including
Amendments 1-4 with all deviations
EN 60950 Second Edition, including
Amendments 1-4
Designed to meet:
UL 1950 Third Edition
CSA 22.2 No. 950-95
IEC 60950 Second Edition, including
Amendments 1-4 with all deviations
EN 60950 Second Edition, including
Amendments 1-4
Table G-1 Access Point Specifications (continued)
Category Access Point with 2.4-GHz Radio Access Point with 5-GHz Radio Module