Specifications

22-5
Cisco Aironet 1200 Series Access Point Installation and Configuration Guide
OL-3446-01
Chapter 22 2.4-GHz Radio Upgrade
Removing a 2.4-GHz Radio
Step 3 Remove the antenna wires from the blank spacer card.
Caution To avoid damaging the antenna wire assemblies, handle them by their connectors.
Step 4 Remove the blank spacer card from the mini-PCI connector.
For instructions on installing the radio card, go to the “Installing a 2.4-GHz Radio” section.
Removing a 2.4-GHz Radio
To remove a 2.4-GHz radio card from your access point, follow the steps below:
Caution The internal access point components and the 2.4-GHz radio can be damaged by ESD from improper
handling.
Step 1 Use your fingers to carefully remove the antenna wire connectors from the 2.4-GHz radio card.
Caution The antenna connectors can be damaged by using a pair of long-nose pliers during the removal
process.
Caution To avoid damaging the antenna wire assemblies, handle them by their connectors.