Specifications

17-10
Cisco Aironet 1200 Series Access Point Installation and Configuration Guide
OL-3446-01
Chapter 17 Configuring SNMP
Displaying SNMP Status
This example shows how to allow read-only access for all objects to members of access list 4 that use
the comaccess community string. No other SNMP managers have access to any objects. SNMP
Authentication Failure traps are sent by SNMPv2C to the host cisco.com using the community string
public.
AP(config)# snmp-server community comaccess ro 4
AP(config)# snmp-server enable traps snmp authentication
AP(config)# snmp-server host cisco.com version 2c public
This example shows how to send Entity MIB traps to the host cisco.com. The community string is
restricted. The first line enables the access point to send Entity MIB traps in addition to any traps
previously enabled. The second line specifies the destination of these traps and overwrites any previous
snmp-server host commands for the host cisco.com.
AP(config)# snmp-server enable traps entity
AP(config)# snmp-server host cisco.com restricted entity
This example shows how to enable the access point to send all traps to the host myhost.cisco.com using
the community string public:
AP(config)# snmp-server enable traps
AP(config)# snmp-server host myhost.cisco.com public
Displaying SNMP Status
To display SNMP input and output statistics, including the number of illegal community string entries,
errors, and requested variables, use the show snmp privileged EXEC command. For information about
the fields in this display, refer to the Cisco IOS Configuration Fundamentals Command Reference for
Release 12.2.