Installation guide

3-7
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
OL-4309-02
Chapter 3 Configuring the Access Point for the First Time
Assigning Basic Settings
• SNMP Community—If your network is using SNMP, enter the SNMP Community name provided
by your network administrator and select the attributes of the SNMP data (also provided by your
network administrator).
Step 7 Click Apply to save your settings. If you changed the IP address, you lose your connection to the access
point. Browse to the new IP address to reconnect to the access point.
Your access point is now running but probably requires additional configuring to conform to your
network’s operational and security requirements. Consult the chapters in this manual for the information
you need to complete the configuration.
Note You can restore the access point to its factory defaults by unplugging the power jack and
plugging it back in while holding down the Mode button for a few seconds, or until the Status
LED turns amber.
Default Settings on the Express Setup Page
Table 3-1 lists the default settings for the settings on the Express Setup page.
Table 3-1 Default Settings on the Express Setup Page
Setting Default
System Name ap
Configuration Server Protocol DHCP
IP Address Assigned by DHCP by default; if
DHCP is disabled, the default
setting is 10.0.0.1
IP Subnet Mask Assigned by DHCP by default; if
DHCP is disabled, the default
setting is 255.255.255.224
Default Gateway Assigned by DHCP by default; if
DHCP is disabled, the default
setting is 0.0.0.0
Radio Service Set ID (SSID) tsunami
Broadcast SSID in Beacon Yes
1
1. When you assign multiple SSIDs, this setting no longer appears.
Role in Radio Network Access point (root)
Optimize Radio Network for Throughput
Aironet Extensions Enable
SNMP Community defaultCommunity