Specifications

2-49
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
channel-match (LBS configuration mode)
Command Modes Configuration interface
Command History
Examples This example shows how to set the access point radio to channel 10 with a center frequency of 2457.
AP(config-if)# channel 2457
This example shows how to set the access point to scan for the least-congested radio channel.
AP(config-if)# channel least-congested
This example shows how to set the frequency to the default setting:
AP(config-if)# no channel
Related Commands
channel-match (LBS configuration mode)
Use the channel-match location based services (LBS) configuration mode command to specify that the
LBS packet sent by an LBS tag must match the radio channel on which the access point receives the
packet. If the channel used by the tag and the channel used by the access point do not match, the access
point drops the packet.
[no] channel-match
Syntax Description This command has no arguments or keywords.
Defaults The channel match option is enabled by default.
Command History
Examples This example shows how to enable the channel match option for an LBS profile:
ap(dot11-lbs)# channel-match
Release Modification
12.2(4)JA This command was introduced.
12.2(8)JA Parameters were added to support the 5-GHz access point radio.
12.2(11)JA Parameters were added to support the 5-GHz bridge radio.
12.4(10b)JA The width option was added to support 2.4-GHz and 5-GHz 802.11n radios.
Command Description
show controllers dot11radio Displays the radio controller information and status
Release Modification
12.3(4)JA This command was introduced.