Specifications

2-41
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
bridge-group unicast-flooding
bridge-group unicast-flooding
Use the bridge-group unicast-flooding configuration interface command to enable unicast flooding for
a specific interface. Use the no form of the command to disable unicast flooding for a specific interface.
bridge-group group unicast-flooding
Syntax Description
Defaults Unicast flooding is disabled by default.
Command Modes Configuration interface
Command History
Examples This example shows how to configure unicast flooding for bridge group 2:
bridge(config-if)# bridge-group 2 unicast-flooding
Related Commands
group Specifies the bridge group to be configured
Release Modification
12.2(11)JA This command was introduced.
Command Description
bridge protocol ieee Enables STP on the bridge
bridge-group
block-unknown-source
Blocks traffic from unknown MAC addresses on a specific
interface
bridge-group path-cost Specifies the path cost for the bridge Ethernet and radio
interfaces
bridge-group port-protected Enables protected port for public secure mode configuration
bridge-group priority Specifies the spanning tree priority for the bridge Ethernet
and radio interfaces
bridge-group spanning-disabled Disables STP on a specific interface
bridge-group
subscriber-loop-control
Enables loop control on virtual circuits associated with a
bridge group