Specifications

2-40
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
bridge-group subscriber-loop-control
bridge-group subscriber-loop-control
Use the bridge-group subscriber-loop-control configuration interface command to enable loop control
on virtual circuits associated with a bridge group. Use the no form of the command to disable loop
control on virtual circuits associated with a bridge group.
For Spanning Tree Protocol (STP) to function properly, subscriber-loop-control must be disabled for
interfaces participating in STP.
bridge-group group subscriber-loop-control
Syntax Description
Defaults When you enable STP for an interface, subscriber loop control is disabled by default.
Command Modes Configuration interface
Command History
Examples This example shows how to disable subscriber loop control for bridge group 2:
bridge(config-if)# no bridge-group 2 subscriber-loop-control
Related Commands
group Specifies the bridge group to be configured
Release Modification
12.2(11)JA This command was introduced.
Command Description
bridge protocol ieee Enables STP on the bridge
bridge-group
block-unknown-source
Blocks traffic from unknown MAC addresses on a specific
interface
bridge-group path-cost Specifies the path cost for the bridge Ethernet and radio
interfaces
bridge-group port-protected Enables protected port for public secure mode configuration
bridge-group priority Specifies the spanning tree priority for the bridge Ethernet
and radio interfaces
bridge-group spanning-disabled Disables STP on a specific interface
bridge-group unicast-flooding Enables unicast flooding for a specific interface