Specifications

2-39

Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges

0L-24115-01

Chapter 2 Cisco IOS Commands for Access Points and Bridges

bridge-group spanning-disabled

Use the bridge-group spanning-disabled configuration interface command to disable Spanning Tree

Protocol (STP) on a specific interface. Use the no form of the command to enable STP on a specific

interface.

For STP to function properly, spanning-disabled must be disabled for interfaces participating in STP.

bridge-group group spanning-disabled

Syntax Description

Defaults STP is disabled by default.

Command Modes Configuration interface

Command History

Examples This example shows how to disable STP for bridge group 2:

bridge(config-if)# bridge-group 2 spanning-disabled

Related Commands

group Specifies the bridge group to be configured

Release Modification

12.2(11)JA This command was introduced.

Command Description

bridge protocol ieee Enables STP on the bridge

bridge-group

block-unknown-source

Blocks traffic from unknown MAC addresses on a specific

interface

bridge-group path-cost Specifies the path cost for the bridge Ethernet and radio

interfaces

bridge-group port-protected Enables protected port for public secure mode configuration

bridge-group priority Specifies the spanning tree priority for the bridge Ethernet

and radio interfaces

bridge-group

subscriber-loop-control

Enables loop control on virtual circuits associated with a

bridge group

bridge-group unicast-flooding Enables unicast flooding for a specific interface