Specifications

v
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Preface
Audience
This guide is for the networking professional using the Cisco IOS command-line interface (CLI) to
manage Cisco Aironet access points and bridges that run Cisco IOS software. Before using this guide,
you should have experience working with Cisco IOS commands and access point and bridge software
features.You also need to be familiar with the concepts and terminology of Ethernet and local area
networking.
Purpose
This guide provides information about new and revised Cisco IOS commands. For information about the
standard Cisco IOS commands, refer to the IOS documentation set available from the Cisco.com home page
at:
http://www.cisco.com/en/US/products/ps6350/tsd_products_support_series_home.html
This guide does not provide procedures for configuring your access point or bridge. For detailed
configuration procedures, refer to the Cisco IOS Software Configuration Guide for Cisco Aironet Access
Points, the Cisco Aironet 1300 Series Outdoor Access Point/Bridge Software Configuration Guide, or
the Cisco Aironet 1400 Series Bridge Software Configuration Guide for this release.
Organization
This guide is organized into these sections:
Chapter 1, “Using the Command-Line Interface,” describes how to access the command modes and use
the command-line interface (CLI) to configure software features.
Chapter 2, “Cisco IOS Commands for Access Points and Bridges,” describes in alphabetical order the
Cisco IOS commands that you use to configure and monitor your access point or bridge.
Appendix A, “List of Supported Cisco IOS Commands,” lists the Cisco IOS commands that access
points and bridges support. Cisco IOS commands that are not in this list have not been tested on access
points and bridges and might not be supported.