Specifications

2-37
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
bridge-group port-protected
bridge-group port-protected
Use the bridge-group port-protected configuration interface command to enable protected port for
public secure mode configuration. In Cisco IOS software, there is no exchange of unicast, broadcast, or
multicast traffic between protected ports.
bridge-group bridge-group
port-protected
Syntax Description
Defaults This command has no defaults.
Command Modes Configuration interface
Command History
Examples This example shows how to enable protected port for bridge group 71:
AP(config-if)# bridge-group 71 port-protected
Related Commands
bridge-group Specifies the bridge group for port protection
Release Modification
12.2(4)JA This command was introduced.
Command Description
bridge protocol ieee Enables STP on the bridge
bridge-group
block-unknown-source
Blocks traffic from unknown MAC addresses on a specific
interface
bridge-group path-cost Specifies the path cost for the bridge Ethernet and radio
interfaces
bridge-group priority Specifies the spanning tree priority for the bridge Ethernet
and radio interfaces
bridge-group spanning-disabled Disables STP on a specific interface
bridge-group
subscriber-loop-control
Enables loop control on virtual circuits associated with a
bridge group
bridge-group unicast-flooding Enables unicast flooding for a specific interface