Specifications

2-31
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
bridge hello-time
bridge hello-time
Use the bridge hello-time global configuration command to configure the interval between hello bridge
protocol data units (BPDUs).
bridge group hello-time seconds
Note This command is supported only on bridges.
Syntax Description
Defaults The default hello time is 2 seconds.
Command Modes Global configuration
Command History
Examples This example shows how to configure the hello time for bridge group 1:
bridge(config)# bridge 1 hello-time 15
Related Commands
group Specifies the bridge group
seconds Specifies the hello interval in seconds
Release Modification
12.2(11)JA This command was introduced.
Command Description
bridge protocol ieee Enables STP on the bridge
bridge aging-time Specifies the length of time that a dynamic entry can remain
in the bridge table from the time the entry is created or last
updated
bridge forward-time Specifies a forward delay interval on the bridge
bridge max-age Specifies the interval that the bridge waits to hear BPDUs
from the spanning tree root
bridge priority Specifies the bridge STP priority