Specifications

2-29
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
bridge aging-time
bridge aging-time
Use the bridge aging-time global configuration command to configure the length of time that a dynamic
entry can remain in the bridge table from the time the entry is created or last updated.
bridge group aging-time seconds
Note This command is supported only on bridges.
Syntax Description
Defaults The default aging time is 300 seconds.
Command Modes Global configuration
Command History
Examples This example shows how to configure the aging time for bridge group 1:
bridge(config)# bridge 1 aging-time 500
Related Commands
group Specifies the bridge group
seconds Specifies the aging time in seconds
Release Modification
12.2(11)JA This command was introduced.
Command Description
bridge protocol ieee Enables STP on the bridge
bridge forward-time Specifies a forward delay interval on the bridge
bridge hello-time Specifies the interval between the hello BPDUs
bridge max-age Specifies the interval that the bridge waits to hear BPDUs
from the spanning tree root
bridge priority Specifies the bridge STP priority