Specifications

2-280
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
wlccp wds mode wds-only
Related Commands
wlccp wds mode wds-only
Use the wlccp wds mode wds-only global configuration command to configure 16b access poins to
operate in the WDS-only mode. After issuing this command and restarting, the access point starts
working in the WDS-only mode. In WDS-only mode, the dot11 subsystems are not initialized and the
dot11 interface related commands cannot be configured. In WDS-only mode, the WDS supports up to
60 infrastructure access points and up to 1200 clients.
This command is supported only on 16 Mb access points (1100 and 1200 series). It is not supported on
32 Mb access points (1130, 1240 series, etc.) It is intended to be used to free up memory necessary to
run as a WDS. To run a 32 Mb access point in WDS-only mode, set the Dot11Radio0 and Dot11Radio1
interfaces to shutdown.
To set the WDS access point to operate in both AP and WDS modes, use the no wlccp wds mode
wds-only command and restart the access point immediately. After the access point restarts, the dot11
radio subsytems initialize. The access point and WDS associate directly to wireless clients. In this mode,
the WDS supports 30 infrastructure access points and 600 clients in addition to 20 direct wireless client
associations.
wlccp wds mode wds-only
Defaults This command has no default
Command Modes Global configuration
Command History
Examples This example shows how to configure WDS-only mode:
ap(config)# wlccp wds mode wds-only
Command Description
clear dot11 aaa
authentication
mac-authen filter-cache
Clear MAC addresses from the MAC authentication cache.
dot11 aaa authentication
mac-authen filter-cache
Enable MAC authentication caching on the access point.
show dot11 aaa
authentication
mac-authen filter-cache
Display MAC addresses in the MAC authentication cache.
show wlccp Display information on devices participating in Cisco Centralized Key
Management (CCKM) and WDS, including addresses in the MAC
authentication cache.
Release Modification
12.3(8)JEB This command was introduced.