Specifications

2-279
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
wlccp wds aaa authentication mac-authen filter-cache
Examples This example shows how to configure the server list for LEAP authentication for client devices:
AP(config)# wlccp authentication-server client leap leap-list1
This example shows how to configure the server list for 802.1x authentication for infrastructure devices
participating in CCKM:
AP(config)# wlccp authentication-server infrastructure wlan-list1
Related Commands
wlccp wds aaa authentication mac-authen filter-cache
Use the wlccp wds aaa authentication mac-authen filter-cache global configuration command to
enable MAC authentication caching on the access point. MAC authentication caching reduces overhead
because the access point authenticates devices in its MAC-address cache without sending the request to
your authentication server. When a client device completes MAC authentication to your authentication
server, the access point adds the client’s MAC address to the cache.
wlccp wds aaa authentication mac-authen filter-cache [timeout seconds]
Syntax Description
Defaults MAC authentication caching is disabled by default. When you enable it, the default timeout value is 1800
(30 minutes).
Command Modes Global configuration
Command History
Examples This example shows how to configure MAC authentication caching with a one-hour timeout:
ap(config)# wlccp wds aaa authentication mac-authen filter-cache timeout 3600
Command Description
authentication network-eap (SSID
configuration mode)
Configures the radio interface (for the specified SSID) to
support network-EAP authentication with optional MAC
address authentication
authentication open (SSID
configuration mode)
Configures the radio interface (for the specified SSID) to
support open authentication and optionally MAC address
authentication or EAP authentication
wlccp ap username Configures an access point to participate in CCKM
wlccp wds priority Configures an access point for WDS
timeout seconds Specifies a timeout value for MAC authentications in the cache.
Release Modification
12.2(15)JA This command was introduced.