Specifications

2-272
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
username (dot1x credentials configuration mode)
Defaults This command has no defaults.
Command Modes Configuration interface
Command History
Examples This example shows how to configure CAC traffic-stream support for a nominal 24 Mbps rate for priority
7 on the 802.11a radio interface:
AP(config)# interface dot11radio 1
AP(config-if)# traffic-stream priority 7 sta-rates nom-24.0
This example shows how to disable CAC traffic-stream priority 7 support on the radio interface:
AP(config-if)# no traffic-stream priority 7 sta-rates
Related Commands
username (dot1x credentials configuration mode)
Use the username dot1x credentials configuration mode command to specify dot1x credential username.
Use the no form of the command to disable the credential username.
[no] username name
Syntax Description
Defaults This command has no defaults.
Command Modes Dot1x credentials configuration interface
Release Modification
12.3(8)JA This command was introduced.
Command Description
admit-traffic Configures CAC admission control on the access point.
admit-traffic (SSID
Configuration Mode)
Enables or disables CAC admission control for the SSID.
show dot11 cac Displays admission control information on the access point.
debug cac Provides debug information for CAC admission control on the access
point.
name Specifies the username for the dot1x credential.