Specifications

2-267
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
station-role install
station-role install
Use the station-role install configuration interface command to configure the bridge for installation
mode. In installation mode, the bridge flashes the LEDs to indicate received signal strength.
station-role install
[ automatic | non-root | root ]
Note This command is supported only on 1310 and 1400 series bridges.
Syntax Description
Defaults When set to defaults, 1400 series bridges start up in install automatic mode and adopt the root role if
they do not associate to another bridge. If a bridge associates to another bridge at start-up, it
automatically adopts the non-root role.
Command Modes Configuration interface
Command History
Examples This example shows how to set the bridge to install mode, non-root:
bridge(config-if)# station-role install non-root
Related Commands
automatic (Optional) Specifies that the bridge automatically selects the root or
non-root role in install mode when it starts up. If the bridge does not
associate to another bridge at start-up, the bridge adopts the root role.
If a bridge associates to another bridge at start-up, it adopts the
non-root role.
non-root (Optional) Specifies that bridge starts up in install mode as a non-root
bridge.
root (Optional) Specifies that bridge starts up in install mode as a non-root
bridge.
Release Modification
12.2(11)JA This command was introduced.
Command Description
station-role Configures the bridge for root, non-root, or install mode