Specifications

2-264
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
station-role
repeater Specifies that the access point is configured for repeater operation.
Repeater operation indicates the access point is not connected to a
wired LAN and must associate to a root access point that is connected
to the wired LAN.
Note This option is not supported on 1400 series bridges.
root access-point Specifies that the access point and bridge is configured for root mode
operation and connected to a wired LAN. This parameter also specifies
that the access point should attempt to continue access point operation
when the primary Ethernet interface is not functional.
Note This option is not supported on 1400 series bridges.
root ap-only Specifies that the device functions only as a root access point. If the
Ethernet interface is not functional, the unit attempts to continue access
point operation. However, you can specify a fallback mode for the
radio.
Note This option is supported only on 1200, 1240AG, and 1310
series access points and bridges.
root bridge Specifies that the access point or bridge operates as the root bridge in
a pair of bridges. This mode does not support wireless client
associations.
Note On the 1200 and 1240AG series access points, this option
supports only point-to-point bridge operation.
Note On the 1300 and 1400 series bridges, this option supports
point-to-point and multipoint bridge operation.
root bridge wireless-clients Specifies that the root bridge mode accepts associations from client
devices.
Note This option is supported only on 1200, 1240AG, and 1310
series access points and bridges.
non-root bridge Specifies that the access point or bridge operates as a non-root bridge
and must associate to a root bridge.
This option is supported only on 1200, 1240AG, 1310, and 1400 series
access points and bridges.
non-root wireless clients Specifies that the non-root bridge mode accepts associations from
client devices.
Note This option is supported only on 1200, 1240AG, and 1310
series access points and bridges.
scanner This option is supported only when used with a WLSE device on your
network. It specifies that the access point operates as a radio scanner
only and does not accept associations from client devices. As a scanner,
the access point collects radio data and sends it to the WDS access
point on your network.
Note This option is supported only on 1100, 1130AG, 1200, 1240,
and 1300 series access points and bridges.