Specifications

2-263
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
station-role
station-role
Use the station-role configuration interface command to set the role of the radio interface. Use the no
form of the command to reset the parameter to the default value.
1100 and 1130 AG Series Access Points
station-role
{repeater |
root [access-point [fallback {shutdown | repeater}] |
scanner |
workgroup-bridge}
1200 and 1240AG Series Access Points
station-role
{non-root [bridge [wireless-clients] | wireless clients] |
repeater |
root [access-point [fallback {shutdown | repeater}] | ap-only] |
root [bridge [wireless-clients]] |
scanner |
workgroup-bridge}
1250 Series Access Points
Note Bridge mode is not supported for 802.11n or non-802.11n data rates. Also, Cisco does not recommend
configuring bridge mode on the 1250 series access point even though the commands for it are available.
350 Series Access Points
station-role
{repeater |
root [fallback {shutdown | repeater}] |
scanner}
1310 Access Points/Bridges
station-role
{install [automatic | non-root | root] |
non-root [bridge | wireless clients] |
repeater |
root [access-point [fallback {shutdown | repeater}] | ap-only] |
root [bridge [wireless-clients]] |
scanner |
workgroup-bridge}
1400 Series Bridges
station-role
{install [automatic | non-root | root] |
non-root bridge |
root bridge}