Specifications

2-259
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
speed (radio interface)
Command History
Examples This example shows how to set the radio data rates for best throughput:
AP(config-if)# speed throughput
This example shows how to set the radio data rates support a low-speed client device while still
supporting higher-speed client devices:
AP(config-if)# speed basic-1.0 2.0 5.5 11.0
The following example shows a speed and mcs setting for an 802.11n 5-GHz radio:
AP(config-if)# interface Dot11Radio0
speed basic-1.0 2.0 5.5 11.0 6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0 m0. m1. m2. m3. m4. m8.
m9. m10. m11. m12. m13. m14. m15.
Related Commands
Release Modification
12.2(4)JA This command was introduced.
12.2(8)JA Parameters were added to support the 5-GHz access point radio.
12.2(11)JA Parameters were added to support the 5.8-GHz bridge radio.
12.2(13)JA Parameters were added to support the 802.11g, 2.4-GHz access point radio.
12.3(2)JA The ofdm parameter was added to the throughput option for the 802.11g,
2.4-GHz access point radio.
12.4(10b)JA Parameters were added to support the 2.4- and 5-GHz 802.11n radios. The
mcs parameter was added.
Command Description
show running-config Displays the current access point operation configuration
speed ofdm Specifies the way that the access point advertises supported
OFDM data rates in beacons and probe responses