Specifications

2-244
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
show wlccp ap mn
show wlccp ap mn
Use the show wlccp ap mn privileged EXEC command to display information on a mobile node.
show wlccp ap [mn mac address]
Note This command is not supported on bridges.
Syntax Description
Defaults This command has no defaults.
Command Modes Privileged EXEC
Command History
Examples This example shows the command you enter on the access point providing WDS to display information
on the mobile nodes:
AP# show wlccp ap mn
MN Mac Address MN IP Address VLAN Wireless Network-ID
-------------- --------------- --------------- -------------------
123a.8a7d.1234 65.103.0.129 702(dynamic) 103 (Radius Assigned)
123a.8a6d.1236 65.101.0.129 100 101(Static)
This example shows the command you enter on the access point providing WDS to display information
on the specified mobile node:
AP# show wlccp ap mn 123a.8a7d.1234
MN Mac Address MN IP Address VLAN Wireless Network-ID
-------------- --------------- --------------- -------------------
123a.8a7d.1234 65.103.0.129 702(dynamic) 103 (Radius Assigned)
Related Commands
mac address Specifies the MAC address of the mobile node.
Release Modification
12.3(8)JA This command was introduced.
Command Description
show dot11 associations Displays the radio association table, radio association
statistics, or selectively display association information about
all repeaters, all clients, a specific client, or basic service
clients.