Specifications

2-242
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
show wlccp
Defaults This command has no defaults.
Command Modes Privileged EXEC
Command History
Examples This example shows the command you enter on the access point providing WDS to list all client devices
(mobile nodes) participating in CCKM:
AP# show wlccp wds mn
wnm status (Optional) This command displays the IP address of the wireless
network manager (WNM) and the status of the authentication between
the WNM and the WDS access point. Possible statuses include not
authenticated, auth in progress, authentication fail, authenticated, and
security keys setup.
wds [ap [detail |
mac-address mac-address
[mn-list]]] |
[mn [detail | mac-address
mac-address]] |
[statistics] |
[nm] |
[aaa authentication
mac-authen filter-cache]
(Optional) When you enter this option on the access point providing
WDS, this option displays cached information about participating
access points and client devices.
• ap—Use this option to display information about access points
participating in CCKM. The command displays each access
point’s MAC address, IP address, state (authenticating,
authenticated, or registered), and lifetime (seconds remaining
before the access point must reauthenticate). Use the mac-addr
sub-option to display information about a specific access point.
Use the mn-list sub-option to display all the mobile nodes
registered through the access point.
• mn—Use this option to display cached information about client
devices, also called mobile nodes. The command displays each
client’s MAC address, IP address, the access point to which the
client is associated (cur-AP), and state (authenticating,
authenticated, or registered). Use the detail option to display the
client’s lifetime (seconds remaining before the client must send a
refreshed registration), SSID, and VLAN ID. Use the
mac-address option to display information about a specific client
device.
• statistics—Use this option to display statistics about devices
participating in WDS and CCKM.
• aaa authentication mac-authen filter-cache—Use this option to
display MAC addresses in the MAC authentication cache.
Release Modification
12.2(11)JA This command was introduced.
12.2(13)JA This command was modified to include radio measurement options.