Specifications

2-228
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
show iapp rogue-ap-list
show iapp rogue-ap-list
Use the show iapp rogue-ap-list privileged EXEC command to display a list of rogue access points.
show iapp rogue-ap-list
Note This command is not supported on bridges.
Syntax Description This command has no arguments or keywords.
Defaults This command has no defaults.
Command Modes Privileged EXEC
Command History
Usage Guidelines The list contains an entry for each access point that a client station reported as a possible rogue access
point. Each list entry contains the following information:
Rogue AP—MAC address of the reported rogue access point
Count—The number of times the access point was reported
Last Rpt Src—The MAC address of the last client to report the rogue access point
R—The last reason code
Prev Rpt Src—The MAC address of any previous client that reported the rogue access point
R—The previous reason code
Last(Min)—The number of minutes since the last report
1st(Min)—The number of minutes since the access point was first reported as a possible rogue
Name—The name of a Cisco rogue access point
The following reason codes are displayed:
1—The rogue was not running 802.1x
2—Authentication with the rogue timed out
3—Bad user password
4—Authentication challenge failed
Release Modification
12.2(4)JA This command was introduced.