Specifications

2-212
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
show dot11 cac
Syntax Description
DefaultsDefaults This command has no defaults.
Command Modes Privileged EXEC
Command History
Examples This example shows how to display CAC information for the access point:
AP# show dot11 cac
Admission Control is allowed on the following SSID(s):
test
The AAC on Dot11Radio0 is 23437
Dot11Radio0, AC:3 :
Configuration: Max-Channel 75, Roam 10
Medium Time Info:
MT max: 23437, MT roam: 3125, MT Consumed: 0, Total MT Left: 23437
Direct Orig MT Left: 20312
Admitted Count 0, Rejected Count 0
Counters:
ssid rejects: 0, rate rejects: 0, tspec violations: 0
bandwidth rejects: 0, active calls: 0
Na_direct=12, Na_roam =14, Channel Used= 0, State = 0
Dot11Radio0, AC:2 :
ACM bit is turned off, all TSPECS accepted
Counters:
ssid rejects: 0, rate rejects: 0, tspec violations: 0 The AAC on Dot11Radio1is 10937
Dot11Radio1, AC:3 :
Configuration: Max-Channel 35, Roam 5
Medium Time Info:
MT max: 10937, MT roam: 1562, MT Consumed: 0, Total MT Left: 10937
Direct Orig MT Left: 9375
Admitted Count 0, Rejected Count 0
Counters:
ssid rejects: 0, rate rejects: 0, tspec violations: 0
bandwidth rejects: 0, active calls: 0
Na_direct=5, Na_roam =6, Channel Used= 0, State = 0
bandwidth rejects: 0, active calls: 0
Na_direct=0, Na_roam =0, Channel Used= 0, State = 2
Related Commands
dot11radio number Displays admission control statistics for the 802.11 radio interface, where
number is 0 for the 802.11a and 802.11g radios or 1 for the 801.11a radio.
Release Modification
12.3(8)JA This command was introduced.
Command Description
admit-traffic (QOS Class
interface configuration mode)
Configures CAC admission control on the access point.
admit-traffic (SSID
configuration mode)
Enables CAC traffic on an SSID.