Specifications

2-201
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
server-address (LBS configuration mode)
server-address (LBS configuration mode)
Use the server-address LBS configuration mode command to specify the IP address of your location
server and the port number on the server to which LBS access points send UDP packets that contain
positioning information.
server-address ip-address port port-number
Syntax Description
Defaults This command has no defaults.
Command Modes LBS configuration mode
Command History
Examples This example shows how to specify the IP address of your location server and a port on the server:
ap(dot11-lbs# server-address 10.91.107.19 port 1024
Related Commands
ip-address Specifies the IP address of the location server on your network.
port-number Specifies the port on the location server to which LBS access points send
UDP packets that contain positioning information. Enter a port number from
1024 to 65535.
Release Modification
12.3(4)JA This command was introduced.
Command Description
channel-match (LBS
configuration mode)
Specifies that the LBS packet sent by an LBS tag must match the radio
channel on which the access point receives the packet
dot11 lbs Creates an LBS profile and enters LBS configuration mode
interface dot11 (LBS
configuration mode)
Enables an LBS profile on a radio interface
method (LBS configuration
mode)
Specifies the location method used in an LBS profile
multicast address (LBS
configuration mode)
Specifies the multicast address that LBS tag devices use when they
send LBS packets
packet-type (LBS
configuration mode)
Specifies the LBS packet type accepted in an LBS profile