Specifications

2-190
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
power inline negotiation
power inline negotiation
Use the power inline negotiation configuration command to configure the Cisco Aironet 1130AG or
1240AG series access point to operate with older switch software that does not support Cisco Intelligent
Power Management power negotiations. Use the no form of the command to disable the access point inline
power settings.
[no] power inline negotiation {prestandard source |
injector{installed | override | MAC address}}
Syntax Description
Defaults The manufacturing default configuration is power inline negotiation prestandard source. If your switch
supports Intelligent Power Management, you should change this setting by using the no power inline
negotiation prestandard source command.
Command Modes Configuration interface
Command History
prestandard source Specifies that the Cisco switch is running older software that does not
support Intelligent Power Management negotiations but is able to supply
sufficient power to the access point.
injector installed Specifies that a power injector is used to supply sufficient power to the
access point and that the Cisco switch is running older software that
does not support Intelligent Power Management.
injector override Specifies a power injector is supplying power and the access point is
configured to override all inline power checks.
Caution When using the power inline negotiation injector override
command, a power injector must always be installed to
prevent a possible overload condition with an underpowered
power source.
injector MAC address Specifies that a power injector is supplying power to the access point and
the access point is connected to a new switch port with the indicated MAC
address.
Enter the MAC address (in xxxx.xxxx.xxxx hexadecimal
format) of the new switch port where the power injector is connected.
Note This command should only be used when you move an access
point and power injector to a different switch port.
Release Modification
12.3(2)JA This command was introduced.
12.3(8)JA The command was modified to include the installed, override, and MAC
address keywords.