Specifications

2-188
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
power client
power client
Use the power client configuration interface command to configure the maximum power level clients
should use for IEEE 802.11b radio transmissions to the access point. The power setting is transmitted to
the client device during association with the access point. Use the no form of the command to not specify
a power level.
2.4-GHz Radio (802.11b)
[no] power client {1 | 5 | 20 | 30 | 50 | 100 | maximum }
1
2.4-GHz Radio (802.11g)
[no] power client {1 | 5 | 10 | 20 | 30 | 50 | 100} | maximum )
1
[no] power client{-1 | 2 | 5 | 8 | 11 | 14 | 17 | 20 | maximum }
2
5-GHz Radio (802.11a)
[no] power client {5 | 10 | 20 | 40} | maximum }
1
[no] power client{-1 | 2 | 5 | 8 | 11 | 14 | 15 | 17 | maximum }
2
[no] power client {-1 | 2 | 5 | 8 | 11 | 14 | 15 | maximum }
2
Note This command is supported only on access points and the 1300 series bridge.
Note The supported client power levels differ on the various access points and the 1300 series bridge.
1. Power settings in mW.
2. Power settings in dBm.