Specifications

2-182
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
packet-type (LBS configuration mode)
packet-type (LBS configuration mode)
Use the packet-type location based services (LBS) configuration mode command to specify the LBS
packet type that accepted in an LBS profile.
packet-type {extended | short}
Syntax Description
Defaults The default packet type is extended.
Command History
Examples This example shows how to specify the packet type used in the LBS profile:
ap(dot11-lbs)# packet-type short
Related Commands
extended Specifies that the access point accepts extended packets from LBS tag
devices. An extended packet contains two bytes of LBS information in the
frame body. If the packet does not contain those two bytes in the frame body,
the access point drops the packet.
short Specifies that the access point accepts short location packets from LBS tag
devices. In short packets, the LBS information is missing from the tag
packet’s frame body and the packet indicates the tag’s transmit channel.
Release Modification
12.3(4)JA This command was introduced.
Command Description
channel-match (LBS
configuration mode)
Specifies that the LBS packet sent by an LBS tag must match the radio
channel on which the access point receives the packet
dot11 lbs Creates an LBS profile and enters LBS configuration mode
interface dot11 (LBS
configuration mode)
Enables an LBS profile on a radio interface
method (LBS configuration
mode)
Specifies the location method used in an LBS profile
multicast address (LBS
configuration mode)
Specifies the multicast address that LBS tag devices use when they
send LBS packets
server-address (LBS
configuration mode)
Specifies the IP address of the location server on your network