Specifications

2-171
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
method (LBS configuration mode)
method (LBS configuration mode)
Use the method location based services (LBS) configuration mode command to specify the location
method used in an LBS profile.
method method
Syntax Description
Defaults The default location method is RSSI.
Command Modes LBS configuration mode
Command History
Examples This example shows how to specify the location method used in the LBS profile:
ap(dot11-lbs)# method rssi
Related Commands
method Specifies the location method used by the access point. In this release, rssi
(in which the access point measures the location packet’s received signal
strength indication) is the only option and is also the default.
Release Modification
12.3(4)JA This command was introduced.
Command Description
channel-match (LBS
configuration mode)
Specifies that the LBS packet sent by an LBS tag must match the radio
channel on which the access point receives the packet
dot11 lbs Creates an LBS profile and enters LBS configuration mode
interface dot11 (LBS
configuration mode)
Enables an LBS profile on a radio interface
multicast address (LBS
configuration mode)
Specifies the multicast address that LBS tag devices use when they
send LBS packets
packet-type (LBS
configuration mode)
Specifies the LBS packet type accepted in an LBS profile
server-address (LBS
configuration mode)
Specifies the IP address of the location server on your network