Specifications

2-154
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
interface dot11 (LBS configuration mode)
interface dot11 (LBS configuration mode)
Use the interface dot11 location based services (LBS) configuration mode command to specify the radio
interface on which an LBS profile is enabled. An LBS profile remains inactive until you enter this
command.
[no] interface dot11 {0 | 1}
Syntax Description
Defaults LBS profiles are disabled by default.
Command History
Examples This example shows how to specify the radio interface for an LBS profile:
ap(dot11-lbs)# interface dot11 0
Related Commands
{0 | 1} Specifies the radio interface. The 2.4-GHz radio is radio 0, and the 5-GHz
radio is radio 1.
Release Modification
12.3(4)JA This command was introduced.
Command Description
channel-match (LBS
configuration mode)
Specifies that the LBS packet sent by an LBS tag must match the radio
channel on which the access point receives the packet
dot11 lbs Creates an LBS profile and enters LBS configuration mode
method (LBS configuration
mode)
Specifies the location method used in an LBS profile
multicast address (LBS
configuration mode)
Specifies the multicast address that LBS tag devices use when they
send LBS packets
packet-type (LBS
configuration mode)
Specifies the LBS packet type accepted in an LBS profile
server-address (LBS
configuration mode)
Specifies the IP address of the location server on your network