Specifications

2-152
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
infrastructure-client
infrastructure-client
Use the infrastructure-client configuration interface command to configure a virtual interface for a
workgroup bridge client. Use the no form of the command to disable the workgroup bridge client virtual
interface.
[no] infrastructure-client
Note Enter this command on an access point or bridge. This command is not supported on devices configured
as workgroup bridges.
Syntax Description This command has no arguments or keywords.
Defaults The default is infrastructure client disabled.
Command Modes Configuration interface
Command History
Usage Guidelines Enable the infrastructure client feature to increase the reliability of multicast messages to workgroup
bridges. When enabled, the access point sends directed packets containing the multicasts, which are
retried if necessary, to the associated workgroup bridge. Enable only when necessary because it can
greatly increase the load on the radio cell.
Examples This example shows how to configure a virtual interface for a workgroup bridge client.
AP(config-if)# infrastructure-client
This example shows how to specify that a workgroup bridge client virtual interface is not supported.
AP(config-if)# no infrastructure-client
Related Commands
Release Modification
12.2(4)JA This command was introduced.
Command Description
show running-config Displays information on the current running access point configuration