Specifications

2-149
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
ids mfp client
ids mfp client
Use the ids mfp client SSID configuration command to enable and explicitly specify the status of
MFP-2. To disable MFP-2 on an access point, use the no form of this command.
[no] ids mfp client{[required | optional] }
Syntax Description
Defaults By default, MFP-2 is disabled.
Command Modes SSID configuration mode
Command History
Examples This example shows how to enable MFP-2 for mandatory authentication:
AP(config-if-ssid)# ids mfp client required
This example shows how to enable MFP-2 for optional authentication:
AP(config-if-ssid) ids mfp client optional
required MFP-2 is mandatory for a client to authenticate to an access point.
optional MFP-2 is optional for a client to authenticate to an access point. In this
case both MFP-2 enabled and disabled clients can authenticate and
associate to an access point.
Release Modification
12.4(3g)JA This command was introduced.