Specifications

2-148
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
iapp standby timeout
iapp standby timeout
Use the iapp standby timeout global configuration command to configure the standby mode polling
timeout value. Use the no form of this command to clear the standby mode polling timeout value.
[no] iapp standby timeout sec
Syntax Description
Defaults When you enable hot standby, the default standby timeout is 20 seconds.
Command Modes Global configuration
Command History
Examples This example shows how to specify the standby mode polling timeout of 1 minute:
AP(config)# iapp standby timeout 60
This example shows how to clear the standby mode timeout value:
AP(config)# no iapp standby timeout
Related Commands
sec Specifies the standby mode polling timeout in seconds
Release Modification
12.2(4)JA This command was introduced.
Command Description
iapp standby mac-address Places the access point into standby mode and identifies the MAC
address of the active access point
iapp standby poll-frequency Specifies the standby mode polling interval
iapp standby
primary-shutdown
Shuts down the radio interface on the monitored access point when
the standby access point takes over