Specifications

2-146
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
iapp standby poll-frequency
iapp standby poll-frequency
Use the iapp standby poll-frequency global configuration command to configure the standby mode
polling interval. Use the no form of this command to clear the access point standby mode poll frequency.
[no] iapp standby poll-frequency sec [mac-address]
Note This command is not supported on bridges.
Syntax Description
Defaults When you enable hot standby, the default poll frequency is 2 seconds.
Command Modes Global configuration
Command History
Examples This example shows how to specify the standby mode poll frequency of 5 minutes:
AP(config)# iapp standby poll-frequency 300
This example shows how to stop or disable the standby mode:
AP(config)# no iapp standby mac-address 0040.9631.81cf
Related Commands
sec Specifies the standby mode poll frequency in seconds
mac-address Specifies the MAC address of an access point
Release Modification
12.2(4)JA This command was introduced.
Command Description
iapp standby mac-address Places the access point into standby mode and identifies the MAC
address of the active access point
iapp standby
primary-shutdown
Shuts down the radio interface on the monitored access point when
the standby access point takes over
iapp standby timeout Specifies the access point standby mode polling timeout value