Specifications

2-145
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
iapp standby mac-address
iapp standby mac-address
Use the iapp standby mac-address global configuration command to configure an access point to be in
standby mode and specify the monitored access point’s MAC address. Use the no form of this command
to disable the access point standby mode.
[no] iapp standby mac-address mac-address
Note This command is not supported on bridges.
Syntax Description
Defaults This command has no default setting.
Command Modes Global configuration
Command History
Examples This example shows how to place the access point in standby mode and indicate the MAC address of the
active access point:
AP(config)# iapp standby mac-address 0040.9631.81cf
This example shows how to stop or disable the standby mode:
AP(config)# no iapp standby mac-address 0040.9631.81cf
Related Commands
mac-address Specifies the MAC address (in xxxx.xxxx.xxxx format) of the active access
point
Release Modification
12.2(4)JA This command was introduced.
Command Description
iapp standby poll-frequency Configures the polling interval in standby mode
iapp standby
primary-shutdown
Shuts down the radio interface on the monitored access point when
the standby access point takes over
iapp standby timeout Configures the polling timeout value in standby mode