Specifications

2-121
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
dot11 wpa handshake timeout
dot11 wpa handshake timeout
Use the dot11 wpa handshake timeout configuration command to adjust the duration before timing out
WPA key packet transmission. This timer value may need to be increased with WPA clients in PSP mode.
dot11 wpa handshake timeout time
Syntax Description
Defaults The default timeout is 100ms.
Command Modes Global configuration
Usage Guidelines The WPA handshake timeout timer starts when the access point's state machine submits the key packet
for transmission. If the client is in power save mode (PSP) at this time, the timer may expire before the
client can come out of PSP mode and the packet can actually be transmitted. For PSP clients, a timeout
value of 1000ms may work more reliably.
dot1x credentials
Use the dot1x credentials global configuration command to configure a dot1x credentials profile. The
no form of the command disables the profile.
[no] dot1x credentials profile-name
Note This command is not supported on c1200 and c1100 platforms.
Syntax Description
Defaults This command has no default setting.
Command Modes Global configuration
Command History
time Specifies the new timeout time. Valid range is from 100ms to 2000ms.
profile-name Specifies the name of the dot1x credentials profile.
Release Modification
12.3(8)JA This command was introduced.