Specifications

2-113
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
dot11 network-map
dot11 network-map
Use the dot11 network-map global configuration command to enable the radio network map feature.
When enabled, the access point broadcasts a IAPP GenInfo Request every collection interval. This
request solicits information from all Cisco access points in the same Layer 2 domain. Upon receiving a
GetInfo Request, the access point sends a unicast IAPP GenInfo Response back to the requester. The
access point uses these IAPP GenInfo Responses to build a network-map.
dot11 network-map [collect-interval]
Syntax Description
Defaults The default collect interval is 5 seconds.
Command Modes Global configuration
Command History
Examples This example shows how to generate a radio network map with a collection interval of 30 seconds:
ap(config)# dot11 network-map 30
You can verify the network map by using the show dot11 network-map EXEC command.
Related Commands
dot11 phone
Use the dot11 phone global configuration command to enable or disable IEEE 802.11 compliance phone
support. Use the no form of this command to disable the IEEE 802.11 phone.
[no] dot11 phone dot11e
Note This command is not supported on bridges.
collect-interval Specifies the time interval between IAPP GenInfo Requests (1 to 60
seconds)
Release Modification
12.2(4)JA This command was introduced.
Command Description
show dot11 network-map Displays the radio network map