Specifications

2-105
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
dot11 ids mfp
dot11 ids mfp
Use the dot11 ids mfp global configuration command to configure Management Frame Protection
(MFP) parameters on the access point.
Note To configure an MFP distributor, the access point must be configured as a WDS.
[no] dot11 ids mfp {detector | distributor | generator}
Defaults This command has no defaults.
Command Modes Global configuration
Command History
Examples This example shows how to configure the MFP detector, enable the MFP gesticulator, and configure the
MFP generator on the access point:
ap(config)# dot11 ids mfp detector
ap(config)# dot11 ids mfp distributor
ap(config)# dot11 ids mfp generator
Related Commands
detector Enables the MFP detector on the access point.
distributor Configures the MFP distributor on the access point.
generator Configures an MFP generator.
Release Modification
12.3(8)JA This command was introduced.
Command Description
show dot11 ids mfp Displays MFP parameters configured on the access point.
debug dot11 ids mfp Debugs MFP operations on the access point.