Specifications

2-103
Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges
0L-24115-01
Chapter 2 Cisco IOS Commands for Access Points and Bridges
dot11 holdoff-time
dot11 holdoff-time
Use the dot11 holdoff-time global configuration command to specify the hold-off time for EAP and
MAC address authentication. The holdoff time is invoked when a client fails three login attempts or fails
to respond to three authentication requests from the access point. Use the no form of the command to
reset the parameter to defaults.
[no] dot11 holdoff-time seconds
Syntax Description
Defaults The default holdoff time is 0 (disabled).
Command Modes Global configuration
Command History
Examples This example shows how to specify a 2-minute hold-off time:
AP(config)# dot11 holdoff-time 120
This example shows how reset the hold-off time to defaults:
AP(config)# dot11 no holdoff-time
Related Commands
seconds Specifies the hold-off time (1 to 65555 seconds)
Release Modification
12.2(4)JA This command was introduced.
Command Description
show running-config Displays information on the current running access point configuration