Installation guide

53
Wi-Fi Location-Based Services—Design and Deployment Considerations
OL-11612-01
Deployment Best Practices
In a similar fashion, the CLI command show rfid detail <mac address> can be used to display detected
RSSI information for an asset tag.
This same information can be obtained graphically via the location map GUI by clicking on either a
WLAN client icon (blue rectangle) or asset tag icon (yellow tag), enabling the location debug checkbox
and then enlarging the miniature location map as stated in WLAN Clients, page 25 and shown in
Figure 32 and Figure 33.
Figure 32 Enabling Location Debug