Datasheet

Cisco Aironet Hard Ceiling Mounting Adapter (AIR-ANTMNTGKIT)

78-19025-01

Installing the Antenna

Antennas with a Nut Fastener

Follow these steps if your antenna uses a nut to mount it to the adapter bracket:

Step 1 Mount the adapter bracket on the ceiling. Follow the procedure in the “Installing the Adapter Bracket”

section on page 3.

Step 2 (Optional) If you need to remove a portion of the adapter bracket to resize it for the antenna you are

installing, do it before proceeding to Step 5. See the “Installing the Antenna” section on page 4 for the

procedure.

Step 3 Remove the nut from the threaded fitting on the antenna.

Step 4 Route the antenna cables one at a time through the hole in the nut and into the cable access opening on

the adapter bracket.

Step 5 Start the nut onto the threaded mounting pedestal on the antenna and tighten it hand tight.

Figure 4 shows a typical installation that uses a nut fastener.

Figure 4 Antenna Installation Using a Nut Fastener

275715