Datasheet

Cisco Aironet Hard Ceiling Mounting Adapter (AIR-ANTMNTGKIT)

78-19025-01

Installing the Antenna

Antennas with Mounting Clips

If your antenna is equipped with mounting clips, follow these steps to install it on the adapter bracket:

Step 1 Determine whether you need to remove the ends of the adapter bracket.

Note Score lines are provided on the adapter bracket. The score lines are used to help you remove the

unwanted portion of the bracket and make a clean break by bending it. Instructions about where

to position your hands on the adapter bracket before beginning to bend it are printed on the

bracket.

Step 2 Once you have determined the portion of the bracket to remove, grasp the bracket at the proper places

on either side of the score line and gently bend the bracket until it breaks off.

Step 3 Install the adapter bracket on the hard ceiling. See the “Installing the Adapter Bracket” section on page 3

for the procedure.

Step 4 Center the clips on the clips on the antenna with adapter bracket.

Step 5 Carefully push the antenna onto the adapter bracket until it will go no further.

Step 6 Route and connect the antenna cables to the wireless device.